User's Manual
Table Of Contents
- 1 About this Guide
- 2 Safety Instructions
- 3 Unpacking
- 4 Overview
- 5 Configuring the Bridge for the First Time
- Before You Start
- Resetting the Bridge to Default Settings
- Obtaining and Assigning an IP Address
- Connecting to the Bridge Locally
- Assigning Basic Settings
- Default Settings on the Express Setup Page
- What To Do Next
- Output Power Level
- Protecting Your Wireless LAN
- Assigning an IP Address Using the CLI
- Using a Telnet Session to Access the CLI
- 6 Mounting the Bridge
- 7 Troubleshooting
- 8 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with Regard to the R&TTE Directive 1999/5/EC
- Declaration of Conformity for RF Exposure
- Declaration of Conformity Statements
- 9 Bridge Specifications
14
THIRD FCC DRAFT (CISCO CONFIDENTIAL)
What To Do Next
After your bridge has basic settings, you need to complete your bridge’s configuration. You might need
to adjust the output power level and other network and security settings.
Output Power Level
Your bridge’s output power level might require adjustment under the following conditions:
• When bridges are
installed less than 328 ft (100 m) apart, you should reduce their output power
to avoid overloading the bridge’s receivers.
To configure your bridge’s output power level, refer to
the Power Levels and Channels for Cisco
Aironet Access Points and Bridges.
IP Address Assigned by DHCP (default setting); if DHCP is disabled, the
defau
lt setting is 10.0.0.1
IP Subnet Mask Assigned by DHCP (default setting); if DHCP is disabled, the
defau
lt setting is 255.255.255.224
Default Gateway Assigned by DHCP (default setting); if DHCP is disabled, the
default s
etting is 0.0.0.0
SNMP defaultCommunity
Read Only
SSID autoinstall
1
Broadcast SSID in Beacon Yes
Role in Radio Network Install
Optimize Radio Network for Throughput
1. During Install Mode, the SSID is autoinstall.
Table 1 Default Settings on the Express Setup Page (continued)
Setting Default