User's Manual
Table Of Contents
- 1 About this Guide
- 2 Safety Instructions
- 3 Unpacking
- 4 Overview
- 5 Configuring the Bridge for the First Time
- Before You Start
- Resetting the Bridge to Default Settings
- Obtaining and Assigning an IP Address
- Connecting to the Bridge Locally
- Assigning Basic Settings
- Default Settings on the Express Setup Page
- What To Do Next
- Output Power Level
- Protecting Your Wireless LAN
- Assigning an IP Address Using the CLI
- Using a Telnet Session to Access the CLI
- 6 Mounting the Bridge
- 7 Troubleshooting
- 8 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with Regard to the R&TTE Directive 1999/5/EC
- Declaration of Conformity for RF Exposure
- Declaration of Conformity Statements
- 9 Bridge Specifications
25
THIRD FCC DRAFT (CISCO CONFIDENTIAL)
Ta b l e 6 Bridge Normal Mode LED Indications
Ethernet
LED
Status
LED
Radio
LED
Meaning
Off — — Ethernet link is down or disabled.
Green — — Ethernet link is operational.
Blinking
gree
n
— — Transmitting and receiving Ethernet packets.
Blinking
ambe
r
— — Transmitting and receiving Ethernet errors.
amber — — Firmware error—disco
nnect and reconnect the power
injector power jack. If the problem continues, contact
technical support for assistance.
— Blinking
gre
en
— Root mode—no remote bridges are associated.
Non-root mode—not associated to the root bridge.
If all bridges are powered up, this could be caused by
incorrect SSID and security settings or improper antenna
alignment. You should check the SSID and security settings
of all bridges and verify antenna alignment.
If the problem continues, contact technical support for
as
sistance.
— Green — Root mode—associated to at least one
remote bridge.
Non-root mode—associated to the root bridge.
This is normal operation.
— Blinking
ambe
r
— General warning—disconnect and reconnect the power
injector power jack. If the problem continues, contact
technical support for assistance.
— Amber — Loading firmware.
Red Amber Red Loading Firmware error—disconne
ct and reconnect the
power injector power. If the problem continues, contact
technical support for assistance.
— — Off Normal operation.
— — Blinking
green
Transmitting and receiving radio packets—normal
o
peration.