User's Manual
Table Of Contents
- 1 About this Guide
- 2 Safety Instructions
- 3 Unpacking
- 4 Overview
- 5 Configuring the Bridge for the First Time
- Before You Start
- Resetting the Bridge to Default Settings
- Obtaining and Assigning an IP Address
- Connecting to the Bridge Locally
- Assigning Basic Settings
- Default Settings on the Express Setup Page
- What To Do Next
- Output Power Level
- Protecting Your Wireless LAN
- Assigning an IP Address Using the CLI
- Using a Telnet Session to Access the CLI
- 6 Mounting the Bridge
- 7 Troubleshooting
- 8 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with Regard to the R&TTE Directive 1999/5/EC
- Declaration of Conformity for RF Exposure
- Declaration of Conformity Statements
- 9 Bridge Specifications
27
THIRD FCC DRAFT (CISCO CONFIDENTIAL)
Power Injector LEDs
The power injector contains three LEDs to provide status information on the wired Ethernet link, the
bridge Ethernet link, and the bridge status. When the power injector is powered up, it sends a constant
discovery tone on the dual-coax cables to the bridge. When the bridge is connected to the dual-coax
cables, it returns the discovery tone to the power injector. When the power injector detects the returned
discovery tone, it applies +48 VDC to the dual-coax cables to the bridge.
When power is applied to the bridge, the bridge activates the bootloa
der and begins the POST
operations. The bridge begins to load the IOS image when the Post operations are successfully
completed. Upon successfully loading the IOS image, the bridge initializes and tests the radio.
The power injector LEDs are shown in Figure 8.
Figure 8 Power Injector LEDs
The power injector LED indications are shown in Table 8.
1 Power jack (+48 VDC) 5 Ethernet port (RJ–45 connector)
2 Power LED 6 Ethernet Activity LED
3 Power injector dual-coax ports (F-Type connectors) 7 Injector Status LED
4 Mode button 8 Uplink Activity LED