User's Manual
Table Of Contents
- 1 About this Guide
- 2 Safety Instructions
- 3 Unpacking
- 4 Overview
- 5 Configuring the Bridge for the First Time
- Before You Start
- Resetting the Bridge to Default Settings
- Obtaining and Assigning an IP Address
- Connecting to the Bridge Locally
- Assigning Basic Settings
- Default Settings on the Express Setup Page
- What To Do Next
- Output Power Level
- Protecting Your Wireless LAN
- Assigning an IP Address Using the CLI
- Using a Telnet Session to Access the CLI
- 6 Mounting the Bridge
- 7 Troubleshooting
- 8 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with Regard to the R&TTE Directive 1999/5/EC
- Declaration of Conformity for RF Exposure
- Declaration of Conformity Statements
- 9 Bridge Specifications
34
THIRD FCC DRAFT (CISCO CONFIDENTIAL)
Browser HTTP Interface
The HTTP interface enables you to browse to the bridge image file on your PC and download the
image to the bridge. Follow the instructions below to use the HTTP interface:
Step 1 Open your Internet browser. You must use Microsoft Internet Explorer (version 5.x or later)
or Netscape Navigator (version 4.x).
Step 2 Enter the bridg
e’s IP address in the browser address line and press Enter. An Enter Network
Password screen appears.
Step 3 Enter your username in the User Name
field.
Step 4 Enter the bridg
e password in the Password field and press Enter. The Summary Status page
appears.
Step 5 Click the System So
ftware tab and then click Software Upgrade. The HTTP Upgrade screen
appears.
Step 6 Click Br
owse to locate the image file on your PC.
Step 7 Click Upl
oad.
For additional information, click the Help i
con on the Software Upgrade screen.
Browser TFTP Interface
The TFTP interface enables you to use a TFTP server on a network device to load the bridge image file.
Follow the instructions below to use a TFTP server:
Step 1 Open your Internet browser. You must use Microsoft Internet Explorer (version 5.x or later)
or Netscape Navigator (version 4.x).
Step 2 Enter the bridg
e’s IP address in the browser address line and press Enter. An Enter Network
Password screen appears.
Step 3 Enter your username in the User Name
field.
Step 4 Enter the bridg
e password in the Password field and press Enter. The Summary Status page
appears.
Step 5 Click Sy
stem Software and then click Software Upgrade. The HTTP Upgrade screen appears.
Step 6 Click TF
TP Upgrade.
Step 7 Enter the IP addr
ess for the TFTP server in the TFTP Server field.