User's Manual
Table Of Contents
- 1 About this Guide
- 2 Safety Instructions
- 3 Unpacking
- 4 Overview
- 5 Configuring the Bridge for the First Time
- Before You Start
- Resetting the Bridge to Default Settings
- Obtaining and Assigning an IP Address
- Connecting to the Bridge Locally
- Assigning Basic Settings
- Default Settings on the Express Setup Page
- What To Do Next
- Output Power Level
- Protecting Your Wireless LAN
- Assigning an IP Address Using the CLI
- Using a Telnet Session to Access the CLI
- 6 Mounting the Bridge
- 7 Troubleshooting
- 8 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with Regard to the R&TTE Directive 1999/5/EC
- Declaration of Conformity for RF Exposure
- Declaration of Conformity Statements
- 9 Bridge Specifications
37
THIRD FCC DRAFT (CISCO CONFIDENTIAL)
accordance with the instructions, may cause harmful interference. However, there is no guarantee that
interference will not occur. If this equipment does cause interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to correct the
interference by one of the following measures:
• Reori
ent or relocate the receiving antenna.
• In
crease separation between the equipment and receiver.
• Connect the equipm
ent to an outlet on a circuit different from which the receiver is connected.
• Consult the dea
ler or an experienced radio/TV technician.
Caution The Part 15 radio device operates on a non-interference basis with other devices operating
at this frequency when using the integrated antennas. Any changes or modification to the
product not expressly approved by Cisco could void the user’s authority to operate this
device.
Caution Within the 5.15 to 5.25 GHz band (5 GHz radio channels 34 to 48) the UNII devices are
restricted to indoor operations to reduce any potential for harmful interference to
co-channel Mobile Satellite System (MSS) operations.
Industry Canada
Canadian Compliance Statement
This Class B Digital apparatus meets all the requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numerique de la classe B respecte les exi
gences du Reglement sur le material broilleur du
Canada.
AIR-BR1430Axx-A-K9 series (AIR-RM1520-58-A-K9) 2461B-102068
AIR-BR1430Pxx-A-K9 series (AIR-RM1520-49-A-K9) 2461B-102067
AIR-BR1430Uxx-A-K9 series (AIR-RM1520-56-A-K9) 2461B-102071