User's Manual
Table Of Contents
- 1 About this Guide
- 2 Safety Instructions
- 3 Unpacking
- 4 Overview
- 5 Configuring the Bridge for the First Time
- Before You Start
- Resetting the Bridge to Default Settings
- Obtaining and Assigning an IP Address
- Connecting to the Bridge Locally
- Assigning Basic Settings
- Default Settings on the Express Setup Page
- What To Do Next
- Output Power Level
- Protecting Your Wireless LAN
- Assigning an IP Address Using the CLI
- Using a Telnet Session to Access the CLI
- 6 Mounting the Bridge
- 7 Troubleshooting
- 8 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with Regard to the R&TTE Directive 1999/5/EC
- Declaration of Conformity for RF Exposure
- Declaration of Conformity Statements
- 9 Bridge Specifications
38
THIRD FCC DRAFT (CISCO CONFIDENTIAL)
This device complies with Class B Limits of Industry Canada. Operation is subject to the following
two conditions:
1. T
his device may not cause harmful interference, and
2. Thi
s device must accept any interference received, including interference that may cause undesired
operation.
Cisco Aironet Access Points are certified to the requiremen
ts of RSS-210. The use of this device in a
system operating either partially or completely outdoors may require the user to obtain a license for
the system according to the Canadian regulations. For further information, contact your local Industry
Canada office.
European Community, Switzerland, Norway, Iceland, and
Liechtenstein
Models:
AIR-BR1430Uxx-E-K9 series