User's Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction to the Access Point
- 3 Unpacking the Access Point
- 4 Configurations
- 5 Becoming Familiar With the Access Point
- 6 Network Deployment Examples
- 7 Preparing the Access Point
- 8 Deploying the Access Point
- 9 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Statement 371-Power Cable and AC Adapter
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EEC
- Declaration of Conformity for RF Exposure
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Operation of Cisco Aironet Access Points in Brazil
- Declaration of Conformity Statements
- 10 In Case of Difficulty
- 11 Cisco 90-Day Limited Hardware Warranty Terms
10
Figure 1 Access Point Bottom Connectors - Models AIR-CAP1552E-x-K9 and AIR-CAP1552H-x-K9
Note Antenna ports 1, 2 and 3 are not shown in Figure 1. These ports are reserved for future use
and will be located on the top of the access point.
1 Antenna port 4 6 Fiber port
2 Antenna port 5 7 PoE-out port
3 Antenna port 6 8 LEDs (Status, Up Link, RF1, RF2)
4 AC power connector for model
AIR-CAP1552H-x-K9 only
9 PoE-in port
5 AC power connector for model
AIR-CAP1552E-x-K9 only
45 6
282137
1 2 3
45
6
789