User's Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction to the Access Point
- 3 Unpacking the Access Point
- 4 Configurations
- 5 Becoming Familiar With the Access Point
- 6 Network Deployment Examples
- 7 Preparing the Access Point
- 8 Deploying the Access Point
- 9 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Statement 371-Power Cable and AC Adapter
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EEC
- Declaration of Conformity for RF Exposure
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Operation of Cisco Aironet Access Points in Brazil
- Declaration of Conformity Statements
- 10 In Case of Difficulty
- 11 Cisco 90-Day Limited Hardware Warranty Terms
34
The format of the TLV block for 1100, 1130, 1200, 1240, 1250, 1300, 1520, and 1552 access points
are listed below:
• Type: 0xf1 (decimal 241)
• Length: Number of controller IP addresses * 4
• Value: List of WLC management interfaces
Configuring Option 43 for Cisco 1000, 1500, and 1550 Series Access Points
To configure DHCP Option 43 for Cisco 1000, 1500, and 1550 series access points in the embedded Cisco
IOS DHCP server, follow these steps:
Step 1 Enter configuration mode at the Cisco IOS CLI.
Step 2 Create the DHCP pool, including the necessary parameters such as default router and name server.
The commands used to create a DHCP pool are as follows:
ip dhcp pool pool name
network IP Network Netmask
default-router Default router
dns-server DNS Server
Where:
pool name is the name of the DHCP pool, such as AP1000.
IP Network is the network IP address where the controller resides, such as
10.0.15.1
Netmask is the subnet mask, such as 255.255.255.0
Default router is the IP address of the default router, such as 10.0.0.1
DNS Server is the IP address of the DNS server, such as 10.0.10.2
Cisco Aironet 1300 Series Cisco AP c1300
Cisco Aironet 1500 Series Cisco AP c1500
1
Cisco AP.OAP1500
2
, Cisco AP.LAP1510
2
, or
Cisco AP.LAP1505
2
Airespace.AP1200
3
Cisco Aironet 1520 Series Cisco AP c1520
Cisco Aironet 1550 Series Cisco AP c1550
1. For controller release 4.1 or later.
2. For controller release 4.0, the VCI depends on the model.
3. For controller release 3.2.
Access Point Vendor Class Identifier (VCI)