User's Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction to the Access Point
- 3 Unpacking the Access Point
- 4 Configurations
- 5 Becoming Familiar With the Access Point
- 6 Network Deployment Examples
- 7 Preparing the Access Point
- 8 Deploying the Access Point
- 9 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Statement 371-Power Cable and AC Adapter
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EEC
- Declaration of Conformity for RF Exposure
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Operation of Cisco Aironet Access Points in Brazil
- Declaration of Conformity Statements
- 10 In Case of Difficulty
- 11 Cisco 90-Day Limited Hardware Warranty Terms
51
Checking the LEDs
Four LEDs, located between the PoE-In and PoE-Out connectors, monitor the status of the access point
power, uplinks, and radios.
Figure 16 identifies and describes the LED functions. Table 2 provides
additional LED signal information.
Figure 16 Access Point LEDs –Shown on the Bottom of Model AIR-CAP1552E-x-K9
1 RF-2 LED—Status of the 5 GHz MIMO
backhaul radio
3 Uplink LED—Ethernet, cable, or fiber status
2 RF-1 LED—Status of the 2.4 GHz MIMO
access radio
4 Status LED—access point and software status
45 6
282144
1 3
2 4