User's Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction to the Access Point
- 3 Unpacking the Access Point
- 4 Configurations
- 5 Becoming Familiar With the Access Point
- 6 Network Deployment Examples
- 7 Preparing the Access Point
- 8 Deploying the Access Point
- 9 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Statement 371-Power Cable and AC Adapter
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EEC
- Declaration of Conformity for RF Exposure
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Operation of Cisco Aironet Access Points in Brazil
- Declaration of Conformity Statements
- 10 In Case of Difficulty
- 11 Cisco 90-Day Limited Hardware Warranty Terms
6
3 Unpacking the Access Point
Follow these steps to unpack the access point:
Step 1 Open the shipping container and carefully remove the contents.
Step 2 Return all packing materials to the shipping container and save it.
Step 3 Ensure that all items listed in the “Package Contents” section on page 6 are included in the
shipment. Check each item for damage. If any item is damaged or missing, notify your
authorized Cisco sales representative.
Package Contents
Each access point package contains the following items:
• One 1550 series access point
• Three liquid-tight adapters
• Two-pin DC power connector
• Ground lug (Panduit PLCD6-10A-L) and screws with lock washers
• Cisco Aironet 1550 Series Outdoor Mesh Access Point Mounting Instructions
• Translated Safety Warnings for Cisco Aironet 1550 Series Outdoor Mesh Access Points
• A printed copy of this guide (Getting Started Guide for Cisco Aironet 1550 Series Outdoor Mesh
Access Points)
Optional Equipment
Depending on what you ordered, the following optional equipment may be part of your shipment:
• Strand mount kit (AIR-ACCSMK1550=)
• Pole mount kit (AIR-ACCPMK1550=)
• Band installation tool for pole mount kit (AIR-BAND-INS-TL=)
• AC power cord, 40 ft. (12.2 m) with North American plug (AIR-CORD-R3P-40NA=)
• AC power cord, 40 ft (12.2 m) with European unterminated end (AIR-CORD-R3P-40UE=)
• Street light power tap (AIR-PWR-ST-LT-R3P=)
• Power injector (AIR-PWRINJ1500-2=)
• 1000BASELX single-mode Rugged SFP (GLC-LX-SM-RGD=)