User Manual
Table Of Contents
- 1 About this Guide
- 2 Safety Instructions
- 3 Unpacking
- 4 Configurations
- 5 Access Point Ports and Connectors
- 6 Configuring the Access Point
- 7 Mounting the Access Point
- 8 Deploying the Access Point on the Wireless Network
- 9 Troubleshooting
- 10 Declarations of Conformity and Regulatory Information
- 11 Configuring DHCP Option 43 and DHCP Option 60
- 12 Access Point Specifications
4
3 Unpacking
To unpack the access point, follow these steps:
Step 1 Unpack and remove the access point and the accessory kit from the shipping box.
Step 2 Return any packing material to the shipping container and save it for future use.
Step 3 Verify that you have received the items listed below. If any item is missing or damaged, contact
your Cisco representative or reseller for instructions.
–
The access point
–
Mounting bracket (optional; selected when you ordered the access point)
–
Adjustable ceiling-rail clip (optional; selected when you ordered the access point)
4 Configurations
The 3602P access point contains two simultaneous dual-band radios, the 2.4-GHz and 5-GHz 802.11n
MIMO radios. For information on the regulatory domains (shown as “x” in the model numbers) see
“Countries Supported” section on page 5.
External Antennas
The 3602P access point is configured with up to four external antennas and two 2.4-GHz/ 5-GHz
dual-band radios. The radio and antennas support frequency bands 2400–2500 MHz and 5150–5850
MHz through a common dual-band RF interface. Features of the external dual-band dipole antennas
are:
• Four RTNC antenna connectors on the top of the access point
• Four TX/RX antennas
These antennas are supported on the 3602P:
• AIR-ANT2524DB-R
• AIR-ANT2524DW-R
• AIR-ANT2524DG-R
• AIR-ANT2524V4C-R
• AIR-ANT2546V4M-R
• AIR-ANT2566P4W-R
ap3602pgetstart.fm Page 4 Friday, September 21, 2012 10:28 AM