User's Manual
Table Of Contents
- Unpacking the Cisco Aironet 600 Series OfficeExtend Access Point
- Cisco Aironet 600 Series OfficeExtend Access Point Overview
- Installation Guidelines
- Cisco Aironet 600 Series OfficeExtend Access Point Radio Frequency Coverage
- Understanding Cisco Aironet 600 Series OfficeExtend Access Point LEDs
- Configuring a Personal SSID on a Cisco Aironet 600 Series OfficeExtend Access Point
- Configuring a Primary IP Address on a Cisco Aironet 600 Series OfficeExtend Access Point
- Viewing the Event Log
- Accessing Online Help
- Troubleshooting
- Cisco Aironet 600 Series OfficeExtend Access Point Local Customer Interface
- Declarations of Conformity and Regulatory Information
REVIEW DRAFT—CISCO CONFIDENTIAL
5
Cisco Aironet 600 Series OfficeExtend Access Point User Guide
Configuring a Personal SSID on a Cisco Aironet 600 Series OfficeExtend Access Point
Configuring a Personal SSID on a Cisco Aironet 600 Series
OfficeExtend Access Point
Follow these steps to log into the GUI of the 600 Series OfficeExtend access point and configure a
personal SSID:
Step 1 Obtain the IP address of your 600 Series OfficeExtend access point from your company’s IT
professional.
Note The default IP address is 10.0.0.1.
Step 2 With the 600 Series OfficeExtend access point connected to your home router, enter the IP address of
the 600 Series OfficeExtend access point in the Address field of your Internet browser
(http:://<ap-ipaddress>) and click Go.
Note Make sure you are not connected to your company’s network using a virtual private network
(VPN) connection.
Step 3 When prompted, enter the username and password to log into the access point.
Note The default username and password are admin and admin.
Step 4 On the 600 Series OfficeExtend Access Point Welcome page, click Enter. The 600 Series Office Extend
Access Point Home page appears (see
Figure 1).