User's Manual
Table Of Contents
- Unpacking the Cisco Aironet 600 Series OfficeExtend Access Point
- Cisco Aironet 600 Series OfficeExtend Access Point Overview
- Installation Guidelines
- Cisco Aironet 600 Series OfficeExtend Access Point Radio Frequency Coverage
- Understanding Cisco Aironet 600 Series OfficeExtend Access Point LEDs
- Configuring a Personal SSID on a Cisco Aironet 600 Series OfficeExtend Access Point
- Configuring a Primary IP Address on a Cisco Aironet 600 Series OfficeExtend Access Point
- Viewing the Event Log
- Accessing Online Help
- Troubleshooting
- Cisco Aironet 600 Series OfficeExtend Access Point Local Customer Interface
- Declarations of Conformity and Regulatory Information
REVIEW DRAFT—CISCO CONFIDENTIAL
8
Cisco Aironet 600 Series OfficeExtend Access Point User Guide
Configuring a Personal SSID on a Cisco Aironet 600 Series OfficeExtend Access Point
Figure 3 Cisco Aironet 600 Series OfficeExtend Access Point Configuration SSID Page
Step 8 In the SSID field, enter the personal SSID that you want to assign to this access point. This SSID will
be locally switched.
Tip Your personal SSID WLAN and your company SSID WLAN are different. When you configure
your personal WLAN, use an SSID name that is different from your company’s SSID to help
avoid confusion.
Step 9 From the Security drop-down boxes, enable either WPA, WPA2, WPA+WPA2, or WEP to set the
security type to be used by this access point.
Step 10 If you chose WPA2/PSK (AES) in Step 9, enter an 8- to 38-character WPA2 passphrase in the Secret
field. If you chose 104 bit WEP, enter a 13-character ASCII key in the Key field.
Step 11 Click Apply to commit your changes.
Note If you ever want to use the Cisco Aironet 600 Series OfficeExtend access point for another
application, you can clear this configuration and return the access point to factory default
settings by clicking Clear Config.