User Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction to the Access Point
- 3 Unpacking the Access Point
- 4 Configurations
- 5 Becoming Familiar With the Access Point
- 6 ISA100 Backbone Router and Infrared-based Security
- 7 Network Deployment Examples
- 8 Preparing the Access Point
- 9 Deploying the Access Point
- 10 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Statement 371-Power Cable and AC Adapter
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EEC
- Declaration of Conformity for RF Exposure
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Operation of Cisco Aironet Access Points in Brazil
- Declaration of Conformity Statements
- 11 In Case of Difficulty
- 12 Cisco 90-Day Limited Hardware Warranty Terms
5
command-line interface (CLI), or the Cisco Network Control System (NCS) network management
system to manage the controller and the associated access points. The access point is compliant with
Wi-Fi Protected Access 2 (WPA2) and employs hardware-based Advanced Encryption Standard (AES)
encryption between wireless nodes to provide end-to-end security.
3 Unpacking the Access Point
Follow these steps to unpack the access point:
Step 1 Open the shipping container and carefully remove the contents.
Step 2 Return all packing materials to the shipping container and save it.
Step 3 Check each item for damage. If any item is damaged, notify your authorized Cisco sales
representative.
Package Contents
Each access point package contains the following items:
• One access point
• Three liquid-tight adapters (used only for non-hazardous locations: AC or DC power input and
Ethernet backhaul)
• Two-pin DC power connector for 12 VDC power
• Ground lug (Panduit PLCD6-10A-L) and screws with lock washers
• Cisco Aironet 1550 Series Outdoor Mesh Access Point Mounting Instructions
• Translated Safety Warnings for Cisco Aironet 1550 Series Outdoor Mesh Access Points
• A printed copy of this guide
Optional Equipment
Depending on what you ordered, the following optional equipment may be part of your shipment:
• Three Dual-Band Omnidirectional Antennas (AIR-ANT2547V-N-HZ=)
• Two Single-Band Omnidirectional Antennas (AIR-ANT2450V-N-HZ=)
• Pole mount kit (AIR-ACCPMK1550=)
• Band installation tool for pole mount kit (AIR-BAND-INS-TL=)