User Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction to the Access Point
- 3 Safety Instructions
- 4 Unpacking
- 5 Configurations
- 6 Access Point Ports and Connectors
- 7 Configuring the Access Point
- 8 Mounting the Access Point
- 9 Deploying the Access Point on the Wireless Network
- 10 Troubleshooting
- 11 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Statement 371-Power Cable and AC Adapter
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EEC
- Declaration of Conformity for RF Exposure
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Operation of Cisco Aironet Access Points in Brazil
- Declaration of Conformity Statements
- 12 Configuring DHCP Option 43 and DHCP Option 60
- 13 Access Point Specifications
- 14 Obtaining Documentation and Submitting a Service Request
5
Step 3 Verify that you have received the items listed below. If any item is missing or damaged, contact
your Cisco representative or reseller for instructions.
–
The access point
–
Mounting bracket (selected when you ordered the access point)
–
Adjustable ceiling-rail clip (selected when you ordered the access point)
5 Configurations
The 1600 series access point contains two simultaneous dual-band radios, the 2.4-GHz and 5-GHz
802.11n MIMO radios, in controller-based mode. The 1600 series access point configurations are:
• AIR-CAP1602E-x-K9 and AIR-SAP1602E-x-K9—two 2.4-GHz/5-GHz dual-band radios with up
to 3 external dual-band dipole antennas
• AIR-CAP1602I-x-K9 and AIR-SAP1602I-x-K9—two 2.4-GHz/5-GHz dual-band radios, with
integrated dual-band inverted-F antennas
For information on the regulatory domains (shown as “x” in the model numbers) see “Regulatory
Domains” section on page 6.
External Antennas
The 1602E models are configured with up to three external dual-band dipole antennas, and two
2.4-GHz/5-GHz dual-band radios. The radios and antennas support frequency bands 2400–2500
MHz and 5150–5850 MHz through a common dual-band RF interface. Features of the external
dual-band dipole antennas are:
• Three RTNC antenna connectors on the top of the access point
• Three TX and three RX antennas
These antennas are supported on the 1602E:
Antenna Part Number Antenna Type Antenna Gain 2 GHz / 5 GHz
(dBi)
AIR-ANT2524DB-R Dual-resonant black dipole 2/4
AIR-ANT2524DW-R Dual-resonant white dipole 2/4
AIR-ANT2524DG-R Dual-resonant gray dipole 2/4
AIR-ANT2524V4C-R Dual-resonant, ceiling-mount omni
(4-pack)
2/4
ap1600getstart.fm Page 5 Tuesday, July 3, 2012 9:21 AM