User Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction to the Access Point
- 3 Safety Instructions
- 4 Unpacking
- 5 Configurations
- 6 Access Point Ports and Connectors
- 7 Configuring the Access Point
- 8 Mounting the Access Point
- 9 Deploying the Access Point on the Wireless Network
- 10 Troubleshooting
- 11 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Statement 371-Power Cable and AC Adapter
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EEC
- Declaration of Conformity for RF Exposure
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Operation of Cisco Aironet Access Points in Brazil
- Declaration of Conformity Statements
- 12 Configuring DHCP Option 43 and DHCP Option 60
- 13 Access Point Specifications
- 14 Obtaining Documentation and Submitting a Service Request
6
Internal Antennas
The 1602I model access points are configured with up to three dual-band inverted-F antennas and two
2.4-GHz/5-GHz dual-band radios.
Each antenna covers both the 2.4 GHz and the 5 GHz bands with a single feed line. The basic features
are as follows:
• Dual-band inverted-F antenna for use in both the 2.4-GHz and 5-GHz bands.
• Antenna unit integrated into 1602I model access points.
• Peak gain is approximately 4 dBi in the 2.4-GHz band and approximately 4 dBi in the 5-GHz
band.
Regulatory Domains
The 1600 series supports the following regulatory domains (shown as “x” in the model numbers):
• -A, -C, -E, -I, -K, -N, -Q, -R, -S, -T, -Z
Countries Supported
Click this URL to browse to a list of countries and regulatory domains supported by the 1600:
www.cisco.com/go/aironet/compliance
6 Access Point Ports and Connectors
The 1602E model access points have external antenna connectors and the LED indictor on the top of
the model, as shown in
Figure 1. The 1602I model access points have integrated antennas and do not
have external connectors on the top of the unit; however, they do have the LED indicator on top of
the unit, as shown in
Figure 2.
AIR-ANT2544V4M-R Dual-resonant omni (4-pack) 4/4
AIR-ANT2566P4W-R Dual-resonant Directional antenna
(4-pack)
6/6
ap1600getstart.fm Page 6 Tuesday, July 3, 2012 9:21 AM