User's Manual

19
347852
To mount the access point on a vertical wall, follow these instructions:
Step 1 Use the mounting bracket as a template to mark four screw hole locations on the mounting surface.
See Figure 8 for the mounting bracket screw hole locations. Use the mounting slotted holes to attach
the unit to the wall.
Figure 8 Mounting Bracket for Wall or Pole Mounting
1
2
3
1
Quick Mount Keyhole Slots (for AP use)
2
Mounting Slots (used with the band clamps)
3
Bracket Mount Holes (use bolts up to 1/4" or
6 mm in diameter)
Step 2 Use four customer-supplied screws and optional screw-anchors to attach the mounting plate to the
mounting surface.
Note If necessary, use suitable screw anchors and an exterior-grade plywood backboard to mount the
access point to stucco, cement or drywall.
Step 3 Screw an M6 x12 mm bolt into each of the four support bolt holes on the back of the access point.
Do not screw the bolt all the way in; leave approximately a 0.13 inch (3.3 mm) space.
Step 4 Position the four bolts on the access point into the keyhole slots on the mounting bracket.
Step 5 Slide the access point down to sit securely in the quick mount notches.