User Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction to the Access Point
- 3 Unpacking the Access Point
- 4 Radio Configuration
- 5 Becoming Familiar With the Access Point
- 6 AP Pole/Wall Mount
- 7 Preparing the Access Point
- 8 Deploying the Access Point
- 9 In Case of Difficulty
- 10 Declarations of Conformity and Regulatory Information
- Regulatory Domains
- FCC Safety Compliance Statement
- Declaration of Conformity for RF Exposure
- Declaration of Conformity with Regard to the EU Directive 1999/5/EC (R&TTE Directive)
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco Access Points in Japan
- Statement 371-Power Cable and AC Adapter
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EEC
- Declaration of Conformity for RF Exposure
- Administrative Rules for Cisco Access Points in Taiwan
- Operation of Cisco Aironet Access Points in Brazil
- Declaration of Conformity Statements
- 11 Warranty
14
Note The FCC limits the amount of power this device can transmit. Power transmitted is a
combination of the amplification of the signal and the antenna gain. The access point has been
designed to operate with the Cisco provided antennas.
Power
Warning
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Warning
This equipment must be externally grounded using a customer-supplied ground wire
before power is applied. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available.
Statement 366
Warning
Do not work on the system or connect or disconnect cables during periods of lightning
activity.
Statement 1001
The 1532E access point supports these power sources:
• DC power—48 volt
• Power-over-Ethernet (PoE)—56 VDC power injector (AIR-PWRINJ1500-2=)
Caution Do not place the power injector in an unprotected outdoor environment because water
could get into the power injector and cause a short circuit and possible fire.
Warning
Connect the unit only to DC power source that complies with the Safety Extra-Low
Voltage (SELV) requirements in IEC 60950 based safety standards
Statement 1033