User Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction to the Access Point
- 3 Unpacking the Access Point
- 4 Radio Configuration
- 5 Becoming Familiar With the Access Point
- 6 AP Pole/Wall Mount
- 7 Preparing the Access Point
- 8 Deploying the Access Point
- 9 In Case of Difficulty
- 10 Declarations of Conformity and Regulatory Information
- Regulatory Domains
- FCC Safety Compliance Statement
- Declaration of Conformity for RF Exposure
- Declaration of Conformity with Regard to the EU Directive 1999/5/EC (R&TTE Directive)
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco Access Points in Japan
- Statement 371-Power Cable and AC Adapter
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EEC
- Declaration of Conformity for RF Exposure
- Administrative Rules for Cisco Access Points in Taiwan
- Operation of Cisco Aironet Access Points in Brazil
- Declaration of Conformity Statements
- 11 Warranty
23
Figure 11 AP wall mounted with Pivoting Mounting Kit
Caution The mounting surface, attaching screws and optional wall anchors must be able to
support a 50-lb (22.7 kg) static weight.
To mount the access point on a vertical wall, follow these instructions:
Step 1 Use the mounting bracket as a template to mark four screw hole locations on the mounting
surface. See
Figure 10 for the mounting bracket screw hole locations.
Step 2 Use four customer-supplied screws and optional screw-anchors to attach the mounting plate
to the mounting surface.
Note If necessary, use suitable screw anchors and an exterior-grade plywood backboard to mount
the access point to stucco, cement or drywall.
Step 3 Match the holes in the bracket plate to the holes in the back of the access point.
Step 4 Screw an M8 x16 bolt into each of the four bolt holes on the back side of the access point and
mounting bracket. (See
Figure 13)
Step 5 Bolt the AP and mounting kit to the wall through the two wall mounting holes on the bracket
(see
Figure 10).
Step 6 Continue with the Grounding the Access Point, page 27.
Grounding rod No
13-mm box-end wrench or socket set No
#6 AWG ground wire No
Materials Required In Kit