User Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction to the Access Point
- 3 Safety Instructions
- 4 Unpacking
- 5 Configurations
- 6 Access Point Ports and Connectors
- 7 Configuring the Access Point
- 8 Mounting the Access Point
- 9 Deploying the Access Point on the Wireless Network
- 10 Troubleshooting
- 11 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Statement 371-Power Cable and AC Adapter
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EEC
- Declaration of Conformity for RF Exposure
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Operation of Cisco Aironet Access Points in Brazil
- Declaration of Conformity Statements
- 12 Configuring DHCP Option 43 and DHCP Option 60
- 13 Access Point Specifications
- 14 Obtaining Documentation and Submitting a Service Request
13
An access point sends all syslog messages to IP address 255.255.255.255 by default when any of the following conditions are
met:
• An access point running software release 5.2 or later has been newly deployed.
• An existing access point running software release 5.2 or later has been reset after clearing the configuration.
If any of these conditions are met and the access point has not yet joined a controller, you can also configure a DHCP server to
return a syslog server IP address to the access point using option 7 on the server. The access point then starts sending all syslog
messages to this IP address.
When the access point joins a controller for the first time, the controller sends the global syslog server IP address (the default is
255.255.255.255) to the access point. After that, the access point sends all syslog messages to this IP address until it is
overridden by one of the following scenarios:
• The access point is still connected to the same controller, and the global syslog server IP address configuration on the
controller has been changed using the config ap syslog host global syslog_server_IP_address command. In this case, the
controller sends the new global syslog server IP address to the access point.
• The access point is still connected to the same controller, and a specific syslog server IP address has been configured for the
access point on the controller using the config ap syslog host specific Cisco_AP syslog_server_IP_address command. In this
case, the controller sends the new specific syslog server IP address to the access point.
• The access point is disconnected from the controller and joins another controller. In this case, the new controller sends its
global syslog server IP address to the access point.
• Whenever a new syslog server IP address overrides the existing syslog server IP address, the old address is erased from
persistent storage, and the new address is stored in its place. The access point also starts sending all syslog messages to the
new IP address provided the access point can reach the syslog server IP address.
You can configure the syslog server for access points and view the access point join information only from the controller CLI.
A detailed explanation of the join process is on Cisco.com at the following URL:
http://www.Cisco.com/en/US/products/ps6366/products_tech_note09186a00808f8599.shtml
11 Declarations of Conformity and Regulatory Information
This section provides declarations of conformity and regulatory information for Cisco Aironet 702W Series Access Points. You
can find additional information at this URL:
www.cisco.com/go/aironet/compliance
Manufacturers Federal Communication Commission Declaration of Conformity
Statement
Models Certification Numbers
AIR-CAP702W-A-K9 LDK102092