User Manual
Table Of Contents
- 1 About this Guide
- 2 Introduction to the Access Point
- 3 Safety Instructions
- 4 Unpacking
- 5 Configurations
- 6 Access Point Ports and Connectors
- 7 Configuring the Access Point
- 8 Mounting the Access Point
- 9 Deploying the Access Point on the Wireless Network
- 10 Troubleshooting
- 11 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Statement 371-Power Cable and AC Adapter
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EEC
- Declaration of Conformity for RF Exposure
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Operation of Cisco Aironet Access Points in Brazil
- Declaration of Conformity Statements
- 12 Configuring DHCP Option 43 and DHCP Option 60
- 13 Access Point Specifications
- 14 Obtaining Documentation and Submitting a Service Request
4
• Wall mounting bracket
5 Configurations
The 702W series access point contains two simultaneous dual-band radios, the 2.4 GHz and 5 GHz 802.11n MIMO radios, in
a controller-based mode.
The 702W series access point configuration is AIR-CAP702W-x-K9—two 2.4 GHz/5 GHz dual-band radios, with two
integrated dual-band antennas.
For information on the regulatory domains (shown as “x” in the model numbers) see “Regulatory Domains” section on page 4.
Internal Antennas
The 702W model access points are configured with two dual-band antennas (two 2.4 GHz and two 5 GHz). The two antennas,
deployed inside the access point, are inside the top housing. The basic features are as follows:
• Dual-Band antennas.
• Antenna elements integrated into 702W access point top housing.
• Peak gains are approximately 2 dBi in the 2.4 GHz band and 4 dBi in the 5 GHz band.
Regulatory Domains
The 702W series supports the following regulatory domains (shown as “x” in the model numbers):
• -A, -C, -D, -E, -H, -I, -K, -N, -Q, -R, -S, -T, -Z
Countries Supported
Click this URL to browse to a list of countries and regulatory domains supported by the 702W:
www.cisco.com/go/aironet/compliance
6 Access Point Ports and Connectors
The 702W model access points have integrated antennas and do not have external connectors on the top of the unit; however,
they do have the LED indicator on top of the unit, as shown in Figure 1.