Installation Guide

ManualsBrandsCisco Systems ManualsElectronicsAironet 802.11ac

Table Of Contents

Cisco Aironet Hyperlocation Module (AIR-ANT-LOC-01=) Installation Guide

Cisco Systems, Inc.

www.cisco.com

Early Beta Draft Only

Cisco Aironet Hyperlocation Module

(AIR-ANT-LOC-01=) Installation Guide

First Published: March 11, 2015

This document outlines the specifications for the Cisco Aironet Hyperlocation Module

(AIR-ANT-LOC-01=) and provides instructions for mounting it.

The following information is provided in this document.

• System Overview, page 2

• System Requirements, page 3

• Safety Precautions, page 4

• Installation Notes, page 5

• Installing the Modules, page 3

• Obtaining Documentation and Submitting a Service Request, page 6

Summary of content (6 pages)

PAGE 1
Ea rly Beta Draft Only Cisco Aironet Hyperlocation Module (AIR-ANT-LOC-01=) Installation Guide First Published: March 11, 2015 This document outlines the specifications for the Cisco Aironet Hyperlocation Module (AIR-ANT-LOC-01=) and provides instructions for mounting it. The following information is provided in this document.
PAGE 2
System Overview Early Beta Draft Only System Overview The Hyperlocation module is a 32 element antenna design that provides 360 degree coverage around supported access points — currently the 3600 and 3700 series APs. It is designed to integrate into the Cisco Aironet Wireless Security and Location Module (RM3010L) providing precise RF Angle of Arrival (AoA) information allowing the operating system a much more granular approach to the location of a client device.
PAGE 3
System Requirements Early Beta Draft Only System Requirements This hyperlocation module is designed for indoor use with Cisco Aironet 3600 and 3700 access point along with the Cisco Aironet Wireless Security and Location module (AIR-RM3010L-UXK9=). Installing the Modules Tools and Equipment Required No specialized tools are required for installing the modules. Mounting the modules Step 1 Remove the modules from the packaging. Step 2 Power down the access point.
PAGE 4
Installing the Modules Early Beta Draft Only Step 5 Peel off the Module Port Protective Cover from the back of the access point to reveal the module port connector, labeled 2 in the following figure. The PCIe connector on the wireless security and location module will go into the AP’s module port connector.
PAGE 5
Installing the Modules Early Beta Draft Only Figure 2 Installing the Wireless Security and Location Module Step 7 Caution Step 8 Screw down the thumb screws on the module, by hand only. Hand tighten each screw until the resistance is obvious and you know you cannot further tighten the screws. Do not use any mechanical tool or device such as pliers or a torque wrench to tighten the screws.
PAGE 6
Obtaining Documentation and Submitting a Service Request Early Beta Draft Only Figure 3 1 View of the final assembly Hyperlocation Module Step 9 2 Wireless Security and Location Module Power up the access point. When the access point boots up, it detects the modules.