Installation Guide
Table Of Contents
Early Beta Draft Only
4
Cisco Aironet Hyperlocation Module (AIR-ANT-LOC-01=) Installation Guide
Installing the Modules
Step 5 Peel off the Module Port Protective Cover from the back of the access point to reveal the module port
connector, labeled 2 in the following figure.
The PCIe connector on the wireless security and location module will go into the AP’s module port
connec
tor.
1 Openings for module’s antennas 2 Removable Module Port Protective Cover
345379
1
2 1
Step 6 Align the PCIe connector with the module port connector on the back of the access point and click the
module down into place. Press firmly on the center of the module to properly seat the PCIe connector
into the AP’s module port connector.