Installation Guide
Table Of Contents
Early Beta Draft Only
5
Cisco Aironet Hyperlocation Module (AIR-ANT-LOC-01=) Installation Guide
Installing the Modules
Figure 2 Installing the Wireless Security and Location Module
Step 7 Screw down the thumb screws on the module, by hand only.
Hand tighten each screw until the resistance is obvious and you know you cannot further tighten the
screws.
Caution Do not use any mechanical tool or device such as pliers or a torque wrench to tighten the screws.
Step 8 Plug in the DART connector of the hyperlocation module in to the DART port on the wireless security
and location module. The final assembly is as shown in
Figure 3.