Installation Guide

2-57
Cisco Aironet 1560 Series Outdoor Access Point Hardware Installation Guide
Chapter 2 Installing the Access Point
Connecting Data Cables
Step 9 Keeping the cable gland nut loose, carefully screw the threaded end of the cable gland into the SFP
module adapter and hand-tighten. Use an adjustable wrench to tighten the threaded end of the cable
gland to 6-7 lb.ft (8.1 to 9.5 Nm).
Step 10 Tighten the cable gland nut until it is properly fastened around the fiber optic cable. Use an adjustable
or open-end wrench to tighten to 2.7 to 3.2 lb.ft (3.66 to 4.34 Nm).
Caution When removing this SFP assembly it is absolutely imperative that you proceed in the reverse order of
this installation. Start by loosening the cable gland's nut.
Figure 2-39 SC Fiber-optic cable
Figure 2-40 Duplex LC Fiber Optic Cable
1 SC optic fiber connector 2 Optic fiber cable
3.00" MAX
.475" MAX
353684
This end goes into
the cable gland
1 2
1 Duplex LC optic fiber connector 2 Optic fiber cable
3.35" MAX
.475" MAX
353685
This end goes into
the cable gland
1 2