Installation Guide

2-44
Cisco Aironet 1560 Series Outdoor Access Point Hardware Installation Guide
Chapter 2 Installing the Access Point
Powering the Access Point
Powering the Access Point
The 1560 access point supports these power sources:
• DC power – 42- 57 VDC
• Power-over-Ethernet (PoE)
The 1560 access point can be powered via the PoE input from an in-line power injector or a suitably
powered switch port. Depending on the configuration and regulatory domain, the required power for full
operation is UPoE.
For the 1562I, UPoE powered switch port or a power injector is required for full operation of the 3x3
MIMO on the 2.4 GHz radio in the regulatory domains that allow for high 2.4 GHz transmit power
(Regulatory domains -A, -D, -F, -K, -N, -Q, -T, -Z). If the 1562I is powered by a PoE+ (802.3at power)
switch port then the access point will automatically disable one of the 2.4 GHz transmitters and the radio
will operate in 2x2 MIMO mode.
Table 2-9 AP 1560 Power Matrix
Connecting a Power Injector
The 1560 Series access point supports the following power injectors:
• AIR-PWRINJ-60RGD1
• AIR-PWRINJ-60RGD2
The power injector provides 56 VDC to the access point over the Ethernet cable and supports a total
end-to-end Ethernet cable length of 100 m (328 ft) from the switch to the access point.
Model Configuration
Regulatory
Domain
Switch
Power
AIR-PWRINJ-60RGD1
AIR-PWRINJ-60RGD2 AIR-PWRINJ6
1
1. The AIR-PWRINJ6 power injector can only be used in an indoor environment. Therefore the cable from the injector must travel from the protected
location to the outside mounted access point.
AD/DC Power Adapter
AIR-PWRADPT-RGD1
1562I 3x3:3 (2.4 GHz) A, B, D, I,
K, N, Q, T,
Z
UPOE Yes No Yes
3x3:3 (5 GHz)
3x3:3 (2.4 GHz) C, E, F, G,
H, L, M, R,
S
UPOE (Future Support)
3x3:3 (5 GHz)
2x2:2 (2.4 GHz) A, B, C, D,
E, F, G, H,
I,
K, L, M,
N, Q, R, S,
T, Z
802.3at
PoE+
Yes
2x2:2 (5 GHz)
1562D 2x2:2 (2.4 GHz) A, B, C, D,
E, F, G, H,
I, K, L, M,
N, Q, R, S,
T, Z
802.3at
PoE+
Yes Yes Yes
2x2:2 (5 GHz)
1562E 2x2:2 (2.4 GHz)
2x2:2 (5 GHz)