Installation Guide

1-8
Cisco Aironet 1560 Series Outdoor Access Point Hardware Installation Guide
Chapter 1 Overview
Hardware Features
Figure 1-5 Left Side Connectors on All Models
Internal Antenna Models
AP1562I (Internal Antenna)
The AP1562I model has an internal omnidirectional antenna. The 1562I access point 802.11b/g/n radio
is used primarily for local access and its 802.11a/n/ac radio for wireless backhaul in the Mesh.
The 2 GHz b/g/n radio operates in 2.4 GHz ISM band. It supports channels 1-11 in the US, 1-13 in
Europe, and 1-13 in Japan. It has 3 transmitters with a maximum total output power of 29 dBm for
802.11b/g/n operation. Output power is configurable for 8 levels in 3 dB steps. It has three receivers that
enable maximum-ratio combining (MRC).
The 5 GHz a/n radio operates in the UNII-1 band (5.15-5.25 GHz), UNII-2 band (5.25 - 5.35 GHz),
UNII-2 Extended/ETSI band (5.47 - 5.725 GHz), and the upper ISM band (5.725 - 5.850 GHz). It has
three transmitters with a maximum total output power of 29 dBm depending on the regulatory domain.
Tx power settings will change depending on the regulatory domain. Output power is configurable in 3
dB steps. Its three receivers enable maximum-ratio combining (MRC).
1 Ground Pad. 2 DC Power-In (covered) (42 V – 57 V).
If the port is not in use, then the covering plug must be
tightened to 12.5 lbf-in torque. Otherwise, it may lead to
water leaking into the access point.
840
1
2