Installation Guide

2-2

Cisco Aironet 1560 Series Outdoor Access Point Hardware Installation Guide

Chapter 2 Installing the Access Point

Unpacking the Access Point

To unpack the access point, follow these steps:

Step 1 Open the shipping container and carefully remove the contents.

Step 2 Return all packing materials to the shipping container, and save it.

Step 3 Ensure that all items listed in “Package Contents” are included in the shipment. If any item is damaged

or missing, notify your authorized Cisco sales representative.

Your shipment may also contain additional equipment as per your order, as listed in Optional Tools and

Hardware From Cisco, page 2-2.

For additional hardware that is required for installation, see Additional Tools and Hardware Required

for Installation, page 2-3.

Package Contents

Each access point package contains the following items:

• One 1560 series access point

• Two-pin DC power connector

• Ground lug and screws with lock washers

• Plastic cable gland and rubber seal

• Weatherization tape and anti-corrosion sealant

• Cisco product documentation and pointer card

Optional Tools and Hardware From Cisco

Depending on what you ordered, the following optional equipment may be part of your shipment:

• External antennas. See the “Installing External Antennas” section on page 2-30.

• Wall/Pole mount bracket AIR-ACC1530-PMK1=

• Wall/Pole mount bracket for AP and AC/DC power adapter AIR-ACC1560-PMK1=

• Wall/Pole mount bracket with tilt mechanism, spare only AIR-ACC1530-PMK2=

• Street light power tap (AIR-PWR-ST-LT-R3P=), works only with the AC/DC power adapter.

• Power injector AIR-PWRINJ6=

• AP cover / Solar Shield for 1560, AIR-ACC1560-CVR=. Spare only.

• AC/DC power adapter, AIR-PWRADPT-RGD1=. Spare only.

• AIR-PWRINJ-60-PMK= mounting bracket for AIR-PWRINJ-60RGDx=

• Spare Parts kit containing extra cable glands, power connector, ground lug, etc.

(AIR-ACC1530-KIT1=)

• AIR-PWRINJ-60RGD1=

• AIR-PWRINJ-60RGD2=