Installation Guide

2-14

Cisco Aironet 1560 Series Outdoor Access Point Hardware Installation Guide

Chapter 2 Installing the Access Point

Mounting the Access Point

Step 7 Locate the access point to its final position. Tighten the band clamps with the wrench so that the access

point does not slide on the pole. Ensure that the clamps are tight enough to not let the AP move.

Step 8 Proceed with installing antennas (only for external antenna models), connecting the data cables,

grounding the access point, powering and configuring the access point.

Figure 2-5 AP Mounted on a Pole

1 One of four M6 keyhole slots for mounting the AP on the

bracket.

3 Top and bottom steel band clamps

2 Top and bottom sets of band clamp slots for passing the

clamps through.

4 Pole (wood, metal, or fiberglass), 2 in. to 8 in. (50 mm to

203 mm) diameter

846