Installation Guide

2-16

Cisco Aironet 1560 Series Outdoor Access Point Hardware Installation Guide

Chapter 2 Installing the Access Point

Mounting the Access Point

Step 6 Using a 10mm wrench, tighten the four bolts that connect the access point to the bracket to a torque of

40 lbf-in.

Step 7 Mount the power supply to the bracket with four #8-32 screws.

Step 8 Locate the access point to its final position. Tighten the band clamps with the wrench. Ensure that the

clamps are tight enough to not let the AP move.

Step 9 Continue with the Grounding the Access Point, page 2-42.

Figure 2-6 AP and Power Supply Mounted on a Pole

1 Power supply. 4 Band clamp slots for passing the clamps through.

2 Screw holes for four #8-32 screws. 5 Steel band clamps.

3 One of four M6 keyhole slots for mounting the AP on the

bracket.

4848