User's Manual
Table Of Contents
- 1 About this Guide
- 2 About the Access Point
- 3 Safety Instructions
- 4 Unpacking the AP
- 5 Ports and Connectors on the AP
- 6 Preparing the AP for Installation
- 7 Installation Overview
- 8 Performing a Pre-Installation Configuration
- 9 Mounting the Access Point
- 10 Powering the Access Point
- 11 Configuring and Deploying the Access Point
- 12 Checking the Access Point LEDs
- 13 Miscellaneous Usage and Configuration Guidelines
- 14 Related Documentation
- 15 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco Aironet Access Points in Japan
- Statement 371—Power Cable and AC Adapter
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EEC
- Declaration of Conformity for RF Exposure
- Generic Discussion on RF Exposure
- This Device Meets International Guidelines for Exposure to Radio Waves
- This Device Meets FCC Guidelines for Exposure to Radio Waves
- This Device Meets the Industry Canada Guidelines for Exposure to Radio Waves
- Cet appareil est conforme aux directives internationales en matière d'exposition aux fréquences radioélectriques
- Additional Information on RF Exposure
- Administrative Rules for Cisco Aironet Access Points in Taiwan
- Operation of Cisco Aironet Access Points in Brazil
- Declaration of Conformity Statements
- 16 Obtaining Documentation and Submitting a Service Request
33
Operating status Blinking Amber Software upgrade is in progress.
Cycling through Green,
Red and Amber
Discovery/join process is in progress.
Rapidly cycling
through Red, Green,
Amber and Off
Access point location command has been
invoked.
Blinking Red Ethernet link is not operational.
Boot loader warnings Blinking Amber Configuration recovery is in progress (Mode
button pushed for 2 to 3 seconds).
Red Ethernet failure.
Image recovery has been initiated (Mode button
pushed for 20 to 30 seconds).
Blinking Green Image recovery is in progress (Mode button
released after being kept pressed for 20 to 30
seconds).
Boot loader errors Red DRAM memory test failure.
Blinking Red and
Amber
Flash file system failure.
Blinking Red and off Environment variable failure.
Bad MAC address.
Ethernet failure during image recovery.
Boot environment failure.
No Cisco image file.
Boot failure.
Cisco AP OS errors Red Software failure.
Try disconnecting and reconnecting power to the
AP.
Cycling through Red,
Green, Amber and off.
General warning. Insufficient inline power.
Table 2 LED Status Indications (continued)
Message Type LED State Possible Messages and Meanings