User's Manual
Table Of Contents
- 1 About this Guide
- 2 About the Network Sensor
- 3 Safety Instructions
- 4 Unpacking the 1800s Network Sensor
- 5 Ports and Connectors on the 1800s
- 6 Installation Overview
- 7 Mounting and Powering the Network Sensor
- 8 Configuring the Network Sensor for Wireless Service Assurance
- 9 Troubleshooting and Resetting the Network Sensor
- 10 Related Documentation
- 11 Declarations of Conformity and Regulatory Information
- Manufacturers Federal Communication Commission Declaration of Conformity Statement
- VCCI Statement for Japan
- Guidelines for Operating Cisco Aironet Network Sensors in Japan
- Statement 371—Power Cable and AC Adapter
- Industry Canada
- Canadian Compliance Statement
- European Community, Switzerland, Norway, Iceland, and Liechtenstein
- Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC & Medical Directive 93/42/EEC
- Declaration of Conformity for RF Exposure
- Generic Discussion on RF Exposure
- This Device Meets International Guidelines for Exposure to Radio Waves
- This Device Meets FCC Guidelines for Exposure to Radio Waves
- This Device Meets the Industry Canada Guidelines for Exposure to Radio Waves
- Cet appareil est conforme aux directives internationales en matière d'exposition aux fréquences radioélectriques
- Additional Information on RF Exposure
- Administrative Rules for Cisco Aironet Network Sensors in Taiwan
- Operation of Cisco Aironet Network Sensors in Brazil
- Declaration of Conformity Statements
- 12 Obtaining Documentation and Submitting a Service Request
7
Note The network sensor is suitable for use in environmental air space in accordance with section
300.22.C of the National Electrical Code and sections 2-128, 12-010(3), and 12-100 of the
Canadian Electrical Code, Part 1, C22.1. You should not install the power supply or power
injector in air handling spaces.
Note Use only with listed Information Technology Equipment (ITE) equipment. For more
information on ITE equipment, refer to article 645 of the latest National Electrical Code
(NEC).
4 Unpacking the 1800s Network Sensor
To unpack the network sensor, follow these steps:
Step 1 Unpack and remove the network sensor and the mounting accessories, from the shipping box.
Step 2 Return any packing material to the shipping container and save it for future use.
Step 3 Verify that you have received the items listed below. If any item is missing or damaged, contact
your Cisco representative or reseller for instructions.
–
The network sensor base unit.
–
One of the optional power accessory modules, selected when you ordered the network sensor.
These modules be ordered separately also.