Installation & Configuration Guide

3-25

Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide

OL-11495-01

Chapter 3 Installing the Router

Attaching the Vertical Cable-Management Trough

Refer to Figure 3-15 and use the following procedure to attach the vertical

cable-management trough.

Step 1 Position the trough so that the access gate opens toward the front of the chassis.

Step 2 Align the top screw holes on the inside panel of the trough with the chassis

standoffs.

Step 3 Hand tighten two screws into the holes to hold the trough in place.

Step 4 Repeat Step 2 and Step 3 for the middle two standoffs and the bottom two

standoffs.

Step 5 Tighten all six screws with a Phillips screwdriver to secure the trough to the

chassis.