Installation & Configuration Guide

7-37
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
OL-11495-01
Chapter 7 Maintaining the Router
Removing and Replacing an AC Power Supply
Step 4 Remove the 2000 W PEM (Figure 7-21):
a. Release the ejector lever by lifting the spring clip.
b. Pivot the lever down to eject the power supply from its backplane connector.
c. Slide the power supply out of its bay while supporting it with your other hand.
Caution The power supply weighs approximately 12 pounds (5.4 kg). Use two hands when
handling the power supply.
Figure 7-21 Removing a 2000 W AC Power Supply
PWR OK
FAULT
TEMP
I LIM
PWR OK
FAULT
TEMP
I LIM
PWR OK
FAULT
TEMP
I LIM
26211