User Guide

8
Release Notes for Cisco ONS 15600 Release 8.0
OL-10906-01
Resolved Caveats for Release 8.0
TL1
CSCsd59138
The wrong SSMs for additional references are displayed in the TL1 RTRV-SYNCN command response
for a 1+1 working line when that line is used as the primary reference for a node. References including
SYNC-NE 2 and 3, and SYNC-BITS are incorrectly reported. To avoid confusion, use CTC to view the
correct SSMs. This issue will be resolved in a future release.
CSCsb72582
You cannot perform an ENT-EQPT for a valid card type when the current equipment state is
OOS-AUMA,MEA&UAS. When the fault PPM comes up as OOS-AUMA,MEA&UAS and then the
ENT-EQPT command is entered using TL1, the command is rejected. This issue will be resolved in a
future release.
CSCeb46234
A TL1 user cannot preprovision IO cards when a filler card is in the slot. Removal of the filler card will
clear the slot and allow the TL1 user to preprovision the IO card. This is by design.
Resolved Caveats for Release 8.0
The following caveats were resolved in Release 8.0.
Maintenance and Administration
CSCsd45025
PPM hardware part numbers are displayed incorrectly in the inventory column. This issue is resolved in
Release 8.0.
Optical Cards
CSCsd88186
A MFGMEM alarm might be incorrectly raised when using an ASAP card with the PIO4 with one SFP,
then replacing that with a PIO1 and an XFP, then returning to the original configuration. When the alarm
is mistakenly raised, it does not clear. You must remove and reinsert the SFP to clear the alarm. This
issue is resolved in Release 8.0.