User's Guide
Table Of Contents
- Introduction
- Package Inventory
- Ripwave Models
- Minimum Computing Requirements
- Physical Characteristics
- Installing an Ethernet Modem
- Installing a USB Modem
- Accessing the Internet
- Troubleshooting
- Installing Ripwave Monitor
- TroubleshootingUsing Ripwave Monitor
- Uninstalling Ripwave Monitor
- Installing Navini Diagnostics (NavDiag)
- TroubleshootingUsing Navini Diagnostics (NavDiag)
- Uninstalling Navini Diagnostics
- Installing & Charging the Battery
- Care & Maintenance
- Upgrading the Modem
- ADDENDUM 1: Ripwave™ Modem - PC Troubleshooting
- ADDENDUM 2: End User Software License Agreement
Ripwave Modem User Guide Navini Networks, Inc.
Physical
Characteristics
If you experience any difficulties with your unit, please contact
your Service Provider or the vendor from whom you obtained your
Ripwave Modem.
The 2.4 GHz Ripwave Modem varies in some aspects from the 2.3,
2.5, 2.6, 3.4 and 3.5 Modems. As well, the Ethernet connection on
any model varies from a USB connection. Notice the differences
highlighted in the photos below and on the following page.
2.4 GHz LED Ripwave Modem
Antenna
Indicator Lights
On/Off Switch
Power Adapter
Connection
Ethernet Cable
Connection
Back of 2.4 E Back of 2.4 U
USB Cable
Connection
Antenna
Indicator Lights
On/Off Switch
Power Adapter
Connection
Ethernet Cable
Connection
Back of 2.4 E Back of 2.4 U
USB Cable
Connection
10 Part #40-00097-00 Rev F v1.0
May 21, 2004