User's Guide

Navini Networks, Inc. Ripwave Modem User Guide
Indicator Lights or LCD
Display, Continued
Installing
Ripwave
Monitor
LED Indicator Lights:
Signal Strength Indicator (SSI) Light
Constant Green: Strong signal
Constant Yellow: Medium signal
Constant Red: Weak signal
Flashing Red: No signal
Battery Indicator Light
Constant Yellow: Battery is charging
Constant Red: Battery is less than 20% charged
Flashing Red: Battery is less than 10% charged
Off: Battery is fully charged or not installed
Power Indicator Light
Constant Green: The Modem is ON (AC or DC power)
LCD Display Symbols
Sync Indicator
Antenna symbol appears when the Modem is in sync and
s
y
nc stren
g
th = 110 dBm.
Signal Strength
Bars
1 bar means signal strength > 110 dBm and 90 dBm
2 bars mean signal strength > 90 dBm and 80 dBm
3 bars mean signal strength > 80 dBm and 70 dBm
4 bars mean signal strength > 70 dBm
Navini’s monitoring software (Ripwave Monitor or Navini
Diagnostics) provides two types of information: signal strength and
quality of the incoming signal. It also can provide information
about the connectivity to the Service Provider’s network. These
displays may be required when troubleshooting Modem problems.
The next few sections will discuss how to install, troubleshoot
with, and uninstall your Ripwave Monitor software. If your
Ripwave Modem has a software release of 4.0 or greater, you do
not have the Ripwave Monitor. You have the Navini Diagnostics
software. You should refer to the sections that discuss how to
install, troubleshoot with, and uninstall your Navini Diagnostics
software.
Before you install your Ripwave Monitor software, please note:
For Windows NT and Windows 2000 you must log into an
account having Administrative privileges in order to install the
Navini Monitor software.
For Windows 95, 98, and 98SE Operating Systems (OS), the
OS CD may be required to complete this installation. If
prompted, insert the OS CD into the CD-ROM drive and accept
the defaults.
Part #40-00097-00 Rev F v1.0 21
May 21, 2004