Installation Manual Part 1

PRELIMINARY
Contents
v
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
6.3.7 Set the Downtilt 6-18
6.3.8 Antenna Orientation 6-19
6.4 Power and Ground Cabling 6-20
6.4.1 Overview 6-20
6.4.2 System Ground Cabling 6-20
6.4.3 System Power Cabling 6-22
6.5 Fiber-Optic Cabling 6-23
6.6 Complete the BWX 8415 Installation 6-23
6.6.1 Install the I/O cable Cover 6-23
6.6.2 Test the Backhaul Connection 6-24
CHAPTER 7 Commissioning 7-1
7.1 Install the Element Management System (EMS) 7-1
7.1.1 ‘Setup the ‘Test’ EMS 7-1
7.1.2 Setting Up Direct Communications Software 7-2
7.1.3 Install the BWX EMS Software and Start & Configure the BWX EMS Server 7-3
7.2 Install Access Services Network Gateway (ASN-GW) Hardware and Broadband Wireless Gateway
(BWG) Software 7-6
7.3 Add and Configure the BWG to the EMS Server 7-7
7.4 Authentication, Authorization, and Accounting (AAA) Server Installation 7-8
7.5 Add and Configure a BWX 8415 Basestation 7-9
7.5.1 Minimum System Configuration Requirements 7-9
7.5.2 Add a BWX 8415 Basestation 7-10
7.5.3 Configure a BWX 8415 Basestation 7-13
7.6 Power Up and Provision the BWX 8415 Basestation 7-28
7.6.1 Prerequisites 7-28
7.6.2 BWX 8415 Basestation Bootup 7-29
7.6.3 Provision the BWX 8415 Basestation 7-35
7.7 Calibration 7-37
7.7.1 What it Means to Calibrate 7-37
7.7.2 Types of Calibration 7-37
7.7.3 Calibration Procedure 7-38
7.8 Add, Configure, Modify and Delete Subscriber Stations (SSs) and Use Related Applications 7-44
7.8.1 Overview 7-44
7.8.2 Supported SS 7-44
7.8.3 Add, Configure, Modify and Delete an SS 7-45
7.8.4 Connection Utility 7-46
7.8.5 BWX WiMAX Diagnostic Tool Operation 7-47