Installation Manual Part 2

PRELIMINARY
6-6
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 6 Installation
6.3 BWX 8415 Installation
6.3 BWX 8415 Installation
Reference:
• Appendix A, “Cisco Recommended Tools”
Check all regulatory requirements prior to installing the BWX 8415 Basestation.
Caution - Refer installation and service to qualified service personnel only. No user serviceable parts inside.
- Installation must be done in accordance with the instructions contained in this manual.
- Read these instructions before installing.
- Save these instructions.
6.3.1 Description
The Antenna Unit (AU) is the part of the BS that contains the eight radiating antenna elements, the heat
exchanger, calibration board, external thermal sensor and optional channel filters. (These filters are
installed on the outside rear of the AU.) An AU (refer to
Figure 6-6) radiates over a sector of 90° or 120°,
configured during commissioning.
Figure 6-6 BWX 8415 Antenna Unit
Note The 8 element AU has 6° of fixed electrical downtilt.
Front View Side View Rear ViewFront View Side View Rear View