Installation Manual Part 3
PRELIMINARY
7-39
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.7.3 Calibration Procedure
Figure 7-43 Full Calibration
Note If you forgot to provision the BS in the EMS database, you will see the error shown in Figure 7-44. Click
on Ok and refer to 7.6.3 Provision the BWX 8415 Basestation.
Figure 7-44 Provision Error
When the calibration is complete, the Full Calibration window changes and displays the finish time and
the result. Note that the result of “Succeeded” means that the calibration finished, not that the
calibration results were successful (
Figure 7-45).
Step 6 Click on Close to close the Full Calibration window
Click on the “Antenna
Ta ble”tab
Click on “Calibrate”
Se lect “Full
Calibration” and
click on “Calibrate”
Click on “Yes”
Click on the “Antenna
Ta ble”tab
Click on the “Antenna
Ta ble”tab
Click on “Calibrate”
Click on “Calibrate”
Se lect “Full
Calibration” and
click on “Calibrate”
Se lect “Full
Calibration” and
click on “Calibrate”
Click on “Yes”
Click on “Yes”
Click on the “Antenna
Ta ble”tab
Click on “Calibrate”
Se lect “Full
Calibration” and
click on “Calibrate”
Click on “Yes”
Click on the “Antenna
Ta ble”tab
Click on the “Antenna
Ta ble”tab
Click on “Calibrate”
Click on “Calibrate”
Se lect “Full
Calibration” and
click on “Calibrate”
Se lect “Full
Calibration” and
click on “Calibrate”
Click on “Yes”
Click on “Yes”
Click on the “Antenna
Ta ble”tab
Click on “Calibrate”
Se lect “Full
Calibration” and
click on “Calibrate”
Click on “Yes”
Click on the “Antenna
Ta ble”tab
Click on the “Antenna
Ta ble”tab
Click on “Calibrate”
Click on “Calibrate”
Se lect “Full
Calibration” and
click on “Calibrate”
Se lect “Full
Calibration” and
click on “Calibrate”
Click on “Yes”
Click on “Yes”