Installation Manual Part 4

PRELIMINARY
7-10
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.5.2 Add a BWX 8415 Basestation
• Active or Passive – Antenna identified
• Antenna Weight (W0) Values – Obtained from the flash drive in the BS
• Whenever you define a new element (BS or SS) in the EMS database, you first add the element, then
configure it by completing various fields through the EMS CAM application. Please refer to the
Cisco OS Release Notes and the BWX Mobile WiMAX Configuration Guide for more datafill
information.
7.5.2 Add a BWX 8415 Basestation
The steps to add a BS are shown in Figure 7-8 through Figure 7-13. Please refer to these figures as you
read the remainder of this section.
Step 1 To add a BS, use the pull-down menu called Action, select Add > BTS, and then WiMAX. Enter the
information in each field. All of these fields must be entered or accept the defaults.
Figure 7-8 Add Screen for BWX 8415 Basestation
Step 2 Select the frequency band for the BS.
To add a BTS, select: Action > Add > Wimax BTS To add a BTS, select: Action > Add > Wimax BTS To add a BTS, select: Action > Add > Wimax BTS To add a BTS, select: Action > Add > Wimax BTS