Installation Manual Part 4
Table Of Contents
- Commissioning
- 7.1 Install the Element Management System (EMS)
- 7.2 Install Access Services Network Gateway (ASN-GW) Hardware and Broadband Wireless Gateway (BWG) Software
- 7.3 Add and Configure the BWG to the EMS Server
- 7.4 Authentication, Authorization, and Accounting (AAA) Server Installation
- 7.5 Add and Configure a BWX 8415 Basestation
- 7.6 Power Up and Provision the BWX 8415 Basestation
PRELIMINARY
7-11
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.5.2 Add a BWX 8415 Basestation
Figure 7-9 Selecting the Frequency Band
Step 3 Set the center frequency per the service provider’s RF Engineering specifications. This will depend upon
the particular spectrum that the service provider has permission to use, and on other radiating equipment
in the geographical area. The Center Frequency setting is selected using the scroll bar.
Note If this BS will be operating in a licensed band, be sure to check to see whether or not it utilizes Channel
Filters. If it does, the center frequency information must be entered exactly as provided on the sticker on
the BS.
Caution Not entering the exact center frequency specified when using Channel Filters may result in destroying
the Power Amplifiers (PA).
Use this pull-down menu to
select the f requency band.
Use this pull-down menu to
select the f requency band.
Use this pull-down menu to
select the f requency band.
Use this pull-down menu to
select the f requency band.