Installation Manual Part 4
Table Of Contents
- Commissioning
- 7.1 Install the Element Management System (EMS)
- 7.2 Install Access Services Network Gateway (ASN-GW) Hardware and Broadband Wireless Gateway (BWG) Software
- 7.3 Add and Configure the BWG to the EMS Server
- 7.4 Authentication, Authorization, and Accounting (AAA) Server Installation
- 7.5 Add and Configure a BWX 8415 Basestation
- 7.6 Power Up and Provision the BWX 8415 Basestation
PRELIMINARY
7-12
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.5.2 Add a BWX 8415 Basestation
Figure 7-10 Setting the Center Frequency
Step 4 Verify that Center Frequency matches the frequency of the Channel Filter and then click Yes to continue.
Note The EMS gives this warning when you click “OK” to continue configuring the BS after setting the center
frequency.
Figure 7-11 Channel Filter Warning
Step 5 Confirm that the BS was added successfully by clicking on Ok.
Adj ust the center frequency by mo ving the blue bar to
the appropriate frequency.
Frequency Range for thi s band
Click on “Ok” to continue.
Adj ust the center frequency by mo ving the blue bar to
the appropriate frequency.
Adj ust the center frequency by mo ving the blue bar to
the appropriate frequency.
Adj ust the center frequency by mo ving the blue bar to
the appropriate frequency.
Frequency Range for thi s bandFr equency Range for thi s bandFr equency Range for thi s band
Click on “Ok” to continue.Click on “Ok” to continue.Click on “Ok” to continue.
This warning is displayed when you are
adding a Basestation that has a Channel
Filter.
This warning is displayed when you are
adding a Basestation that has a Channel
Filter.
This warning is displayed when you are
adding a Basestation that has a Channel
Filter.
This warning is displayed when you are
adding a Basestation that has a Channel
Filter.