Installation Manual Part 4

PRELIMINARY
7-13
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.5.3 Configure a BWX 8415 Basestation
Figure 7-12 Basestation Added Successfully
Step 6 Next, you will see the new BS added to the list under the BTS tab. Double-click on the BTS entry to
select the BS.
Figure 7-13 Basestation added to the BTS tab
7.5.3 Configure a BWX 8415 Basestation
Configuring the BS consists of setting the following sets of parameters: General, GPS, Layer 1, Layer
2, R6, and CAC.
7.5.3.1 Set the General Parameters
The steps to set the General parameters are shown in Figure 7-14 through Figure 7-19. Please refer to
these figures as you read the remainder of this section.
Click on "Ok" to
continue
Click on "Ok" to
continue
Click on "Ok" to
continue
Click on "Ok" to
continue
The new BWX 8415 basestation appears in the Element ID List area.
Notice that the BTS is “Unprovisioned”. Notice also that the version
number of the current software load is not known at this time. To select
the BTS, double-click anywhere on its line of information.
The new BWX 8415 basestation appears in the Element ID List area.
Notice that the BTS is “Unprovisioned”. Notice also that the version
number of the current software load is not known at this time. To select
the BTS, double-click anywhere on its line of information.
The new BWX 8415 basestation appears in the Element ID List area.
Notice that the BTS is “Unprovisioned”. Notice also that the version
number of the current software load is not known at this time. To select
the BTS, double-click anywhere on its line of information.
The new BWX 8415 basestation appears in the Element ID List area.
Notice that the BTS is “Unprovisioned”. Notice also that the version
number of the current software load is not known at this time. To select
the BTS, double-click anywhere on its line of information.