Installation Manual Part 4

PRELIMINARY
7-18
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.5.3 Configure a BWX 8415 Basestation
7.5.3.2 Set the GPS Parameters
Note The GPS receiver module supports WiMAX certification requirements for high-resolution timing. The
GPS receiver module provides 1 pulse per second (1 PPS) and 10 MHz source.
Step 1 From the BTS tab, click on the BTS which is to be configured.
Step 2 Right-click on the selected BTS, pull down the Action menu and select Configure.
Figure 7-20 Configuring the BWX Basestation
Step 3 Select System > GPS and then click on Configure.
Click on t he
first BTS.
Notic e that
it turns blue
to indicate
that it is
select ed.
Four of the five icons (Alarm View, Net View, Configure…,
and BWX WiMAX Diagnostic Tool) are now selectable (that
is, not grayed out).
Right-click on the selected
BTS and pull down the
“Acti on”menu. Select
“Confi gure…”
Click on t he
first BTS.
Notic e that
it turns blue
to indicate
that it is
select ed.
Click on t he
first BTS.
Notic e that
it turns blue
to indicate
that it is
select ed.
Click on t he
first BTS.
Notic e that
it turns blue
to indicate
that it is
select ed.
Four of the five icons (Alarm View, Net View, Configure…,
and BWX WiMAX Diagnostic Tool) are now selectable (that
is, not grayed out).
Four of the five icons (Alarm View, Net View, Configure…,
and BWX WiMAX Diagnostic Tool) are now selectable (that
is, not grayed out).
Four of the five icons (Alarm View, Net View, Configure…,
and BWX WiMAX Diagnostic Tool) are now selectable (that
is, not grayed out).
Four of the five icons (Alarm View, Net View, Configure…,
and BWX WiMAX Diagnostic Tool) are now selectable (that
is, not grayed out).
Right-click on the selected
BTS and pull down the
“Acti on”menu. Select
“Confi gure…”
Right-click on the selected
BTS and pull down the
“Acti on”menu. Select
“Confi gure…”
Right-click on the selected
BTS and pull down the
“Acti on”menu. Select
“Confi gure…”
Right-click on the selected
BTS and pull down the
“Acti on”menu. Select
“Confi gure…”