Installation Manual Part 4

PRELIMINARY
7-19
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.5.3 Configure a BWX 8415 Basestation
Figure 7-21 Selecting the GPS Parameters
Step 4 Click on Auto Survey to configure the GPS receiver module.
Step 5 Click on Ok to accept the changes.
Figure 7-22 Updating Parameter Fields
Step 6 Click on Yes in the warning box that will appear when the Auto Survey action is triggered.
Note The Auto Survey action can take up to four (4) hours to complete. An alarm (GPS Receiver Auto Survey
in progress) will appear while the survey is in progress and the BS must be reset for the changes to take
effect.
Step 7 Click on Ok to continue.
With “S ys t em – G en era l” selected,
Click on “Co nfigure…”.
With “S ys t em – G en era l” selected,
Click on “Co nfigure…”.
With “ Sys t e m – G P S ” selected,
Click on “Co nfigure…”.
With “S ys t em – G en era l” selected,
Click on “Co nfigure…”.
With “S ys t em – G en era l” selected,
Click on “Co nfigure…”.
With “ Sys t e m – G P S ” selected,
Click on “Co nfigure…”.
With “S ys t em – G en era l” selected,
Click on “Co nfigure…”.
With “S ys t em – G en era l” selected,
Click on “Co nfigure…”.
With “ Sys t e m – G P S ” selected,
Click on “Co nfigure…”.
Click on “Ok” to accept
the changes.
Click on “Auto Survey.”
Click on “Ok” to accept
the changes.
Click on “Auto Survey.”Click on “Auto Survey.”