Installation Manual Part 4

PRELIMINARY
7-20
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.5.3 Configure a BWX 8415 Basestation
Figure 7-23 Confirmation of Successful Configuration
7.5.3.3 Set the Layer 1 Parameters
The steps to set the Performance parameters are shown in Figure 7-24 through Figure 7-29. Please refer
to these figures as you read the remainder of this section.
Step 1 Select Air Interface> Layer 1> Layer 1 Tables and then click on Show Configuration and Configure.
Figure 7-24 Selecting the Performance Parameters
Step 2 Select the General tab.
Step 3 Click on Enable Advance Operations to modify additional fields.
Step 4 Click on Yes in the Warning box.
Click on “Ok” to continue.Click on “Ok” to continue.Click on “Ok” to continue.
In order to make changes, click on “Configure”.In order to make changes, click on “Configure”.
Click on “Show Configuration”
to view the current “Layer 1”
configuration.
Click on “Show Configuration”
to view the current “Layer 1”
configuration.
Click on “Show Configuration”
to view the current “Layer 1”
configuration.
Notice there are 3 tabs . Nothi ng
can b e changed at thi s level. All
fields are grayed out because
“Show Configuration” was
selected.
Click on “Layer1 Ta bles”.
Cl ick on this icon to op en the “Air Interface” branch of the tree.
In order to make changes, click on “Configure”.In order to make changes, click on “Configure”.In order to make changes, click on “Configure”.In order to make changes, click on “Configure”.
Click on “Show Configuration”
to view the current “Layer 1”
configuration.
Click on “Show Configuration”
to view the current “Layer 1”
configuration.
Click on “Show Configuration”
to view the current “Layer 1”
configuration.
Click on “Show Configuration”
to view the current “Layer 1”
configuration.
Click on “Show Configuration”
to view the current “Layer 1”
configuration.
Click on “Show Configuration”
to view the current “Layer 1”
configuration.
Notice there are 3 tabs . Nothi ng
can b e changed at thi s level. All
fields are grayed out because
“Show Configuration” was
selected.
Notice there are 3 tabs . Nothi ng
can b e changed at thi s level. All
fields are grayed out because
“Show Configuration” was
selected.
Click on “Layer1 Ta bles”.Click on “Layer1 Ta bles”.Click on “Layer1 Ta bles”.
Cl ick on this icon to op en the “Air Interface” branch of the tree. Cl ick on this icon to op en the “Air Interface” branch of the tree. Cl ick on this icon to op en the “Air Interface” branch of the tree.