Installation Manual Part 4

Table Of Contents

PRELIMINARY

7-21

BWX 8415 Basestation Installation and Commissioning Guide

OL-19519-01

Chapter 7 Commissioning

7.5.3 Configure a BWX 8415 Basestation

Figure 7-25 Enabling Advanced Operation for Layer 1 Parameters

Step 5 Enter the values in the following fields, as shown in Figure 7-26 below:

• Operating Level Mode = use value given by service provider (Auto/Manual)

• Operating Level = use value given by service provider (100dB/80dB/60dB)

• Antenna Power = use value given by service provider (20-35)

• Antenna Type = Panel

• Down Tilt = use value given by service provider

• Azimuth = per directions given to Installer

• Channel Filter Part Number = from sticker on channel filter

• Channel Filter Start Freq = use value given by service provider

• Channel Filter Stop Freq = use value given by service provider

• Antenna Pattern = use value given by service provider (120/90)

Select the General tab.

Click on Yes.

Select the General tab. Select the General tab. Select the General tab.