Installation Manual Part 4

PRELIMINARY
7-22
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.5.3 Configure a BWX 8415 Basestation
Figure 7-26 Changing the Layer 1 Parameters
Step 6 Select the second tab, Antenna Table.
Step 7 Select Modify All to change the values of any field.
Figure 7-27 Antenna Table Tab
Step 8 Select the third tab, W0 Table.
Update the General parameters,
per the si te specifications.
Update the General parameters,
per the si te specifications.
Update the General parameters,
per the si te specifications.
Update the General parameters,
per the si te specifications.
Select the s econd tab.
These values are returned by
the “full calibration” process.
These values are loaded from
The f lash m emory within the BS
(D iscuss ed in the next section.)
These fields turn transmission and reception, for
each antenna element, ON or OFF individually.
Click on “Modify All” to c hange
any of the fields.
Select the s econd tab. Select the s econd tab.
These values are returned by
the “full calibration” process.
These values are returned by
the “full calibration” process.
These values are returned by
the “full calibration” process.
These values are loaded from
The f lash m emory within the BS
(D iscuss ed in the next section.)
These values are loaded from
The f lash m emory within the BS
(D iscuss ed in the next section.)
These values are loaded from
The f lash m emory within the BS
(D iscuss ed in the next section.)
These fields turn transmission and reception, for
each antenna element, ON or OFF individually.
These fields turn transmission and reception, for
each antenna element, ON or OFF individually.
Click on “Modify All” to c hange
any of the fields.
Click on “Modify All” to c hange
any of the fields.
Click on “Modify All” to c hange
any of the fields.