Installation Manual Part 4
Table Of Contents
- Commissioning
- 7.1 Install the Element Management System (EMS)
- 7.2 Install Access Services Network Gateway (ASN-GW) Hardware and Broadband Wireless Gateway (BWG) Software
- 7.3 Add and Configure the BWG to the EMS Server
- 7.4 Authentication, Authorization, and Accounting (AAA) Server Installation
- 7.5 Add and Configure a BWX 8415 Basestation
- 7.6 Power Up and Provision the BWX 8415 Basestation
PRELIMINARY
7-24
BWX 8415 Basestation Installation and Commissioning Guide
OL-19519-01
Chapter 7 Commissioning
7.5.3 Configure a BWX 8415 Basestation
7.5.3.4 Other Parameters – Optimized Settings
The rest of the Layer1 and Layer2 values will be left at the defaults by the Installer, unless otherwise
specified (see
Figure 7-30).
Figure 7-30 Defaulted Layer1 / Layer2 / Layer3 Values
7.5.3.5 Set the R6 Interface Parameters
The steps to set the R6 Interface parameters are shown in Figure 7-31 through Figure 7-33. Please refer
to these figures as you read the remainder of this section.
Step 1 Select Mobility > R6 Interface and then click on Show Configuration and Configure.
Layer1 / Layer2 / Layer3 TabsLayer1 / Layer2 / Layer3 TabsLayer1 / Layer2 / Layer3 TabsLayer1 / Layer2 / Layer3 TabsLayer1 / Layer2 / Layer3 TabsLayer1 / Layer2 / Layer3 TabsLayer1 / Layer2 / Layer3 TabsLayer1 / Layer2 / Layer3 TabsLayer1 / Layer2 / Layer3 TabsLayer1 / Layer2 / Layer3 TabsLayer1 / Layer2 / Layer3 TabsLayer1 / Layer2 / Layer3 Tabs